UPLOAD DOWNLOAD UTILITY |
![]()
|
JV33 FIRMWARE
|
![]()
|
![]()
|
JV34 / TS34
|
![]()
|
![]()
|
Changing the ink type
JV3
1: SHUT DOWN the JV3
2: PRESS key "<" ">" AT THE SAME TIME when OPEN THE DEVICE
3: When the device ready, PRESS KEY "END" 1 time.
4: Enter into into menu"SYSTEM PARAMETER"
5: Choose and enter"Ink 1 parameter".
6: Look for Item 93 and change the value "3" to "0"
7: Exit and choose the ink type you want shows on the LCD.
8: After been chosen, The device will advise you to insert the cartridges. Disregard it and shut down the device directly.
9: Go through steps 1 through 6 again --> but this time change value "0" to "3".
10: After set, the device will ask you to insert the cartridges.
11: insert the proper cartridge.
JV33 / JV5
Enter technician mode:
1: Turn off the front power.
2: Press "<", ">" at the same time you power on.
3: Find and the press Enter on menu for "SystemParam"
4: Go to #46 SUPPORT 2 (change the value to "2")
How to change ink type:
1: Enter menu ---> 2: Functions 3: Parameter Function >RUNNING PARAM.
2: #121, change value "1" to "0" -- if already "0" change "0" to "1"
3: On restart the device will ask you to choose a ink type on the LCD panel.
JV3
1: SHUT DOWN the JV3
2: PRESS key "<" ">" AT THE SAME TIME when OPEN THE DEVICE
3: When the device ready, PRESS KEY "END" 1 time.
4: Enter into into menu"SYSTEM PARAMETER"
5: Choose and enter"Ink 1 parameter".
6: Look for Item 93 and change the value "3" to "0"
7: Exit and choose the ink type you want shows on the LCD.
8: After been chosen, The device will advise you to insert the cartridges. Disregard it and shut down the device directly.
9: Go through steps 1 through 6 again --> but this time change value "0" to "3".
10: After set, the device will ask you to insert the cartridges.
11: insert the proper cartridge.
JV33 / JV5
Enter technician mode:
1: Turn off the front power.
2: Press "<", ">" at the same time you power on.
3: Find and the press Enter on menu for "SystemParam"
4: Go to #46 SUPPORT 2 (change the value to "2")
How to change ink type:
1: Enter menu ---> 2: Functions 3: Parameter Function >RUNNING PARAM.
2: #121, change value "1" to "0" -- if already "0" change "0" to "1"
3: On restart the device will ask you to choose a ink type on the LCD panel.